Add H2O and Go!

Soaking Silver Eagle cooling products in water activates the cooling process. When activated, special water-retaining, hydrophilic fibers in the batting capture and lock in a finite amount of water. The hydrophobic fill evenly distributes and surrounds these water-charged fibers with air, creating an ideal environment for evaporation. This combination of hydrophilic and hydrophobic fibers delivers a slow, controlled release of moisture, enabling hours of evaporative cooling comfort.

Silver Eagle caps, hats and Do-Rags are activated by soaking them in tap water. For maximum cooling time, allow them to absorb water into the fabric's core for 3 to 5 minutes. Wring out excessive moisture and towel-dry the inner surface if desired.

For shorter periods of cooling, turn the gear over and pour a limited amount of water into the liner, allowing it to fully soak into the fabric's core.

Although you may completely wring out excess water from the headgear, the material offers increased and prolonged effectiveness if aggressive wringing is avoided.

The Silver Eagle Cap's bill is made of a quality plastic that is not affected by water.

1. Pre-treat stains with stain remover.
2. Presoak 5 minutes before adding a mild detergent.
3. Wash as normal on gentle cycle. DO NOT USE CHLORINE BLEACH.
4. Line dry or machine dry on low heat.
5. Thoroughly dry product before storing.

Note: Do not freeze Silver Eagle evaporative cooling products.